20, 1st Floor, Jalan Damar,
Permatang Damar Laut,
11960 Bayan Lepas,
Pulau Pinang, Malaysia.
Previous | 3 / 4 | Next |
Power range up to 100.000W
Output voltage 6,5V up to 350V, continuously adjustable from zero to maximum
The mains voltage is transformed to the appropriate level. On the secondary side of the transformer is a thyristor controlled rectifier stage (phase cutting circuit), the output of which is used to charge a capacitor bank. This capacitor bank is also connected to the final series regulating transistor output stage. By controlling the conduction angle of the thyristors after each zero-crossing of the sinusoidal voltage, the flow of energy is regulated in such a way as to have a defined voltage drop across the final series transistor stage (pre-regulation). The performance of the final series transistor stage defines the final stability of the output voltage (main regulation).
The mains voltage is first transformed to the appropriate level. On the secondary side of the transformer is a thyristor controlled rectifier stage (phase cutting circuit). The rectified voltage is smoothed by a LC-filter.
The mains voltage is transformed to the appropriate level and rectified. The rectified voltage charges a bank of capacitors of the intermediate circuit to a constant voltage, which it is given via a set of power transistors to the output. The series transistor defines the final stability of the output voltage and the regulation speed. Optionally a set of power transistors parallel to the output can act as a current sink to provide active pull down ability. The design of linear regulated power supplies is optimized for fast programming speed.
Bipolar linear regulated power supplies supply one output voltage, where the value and polarity is adjustable. The mains voltage is transformed to the appropriate level and rectified. The rectified voltage charges a bank of capacitors of the intermediate circuit to a constant voltage, which it is fed, via a set of serial power transistors, to the output. The output stages of the positive and the negative circuits are switched together in a push-pull manner. The regulation transistors define the final stability of the output voltage and the regulation speed. Bipolar power supplies are able to operate as 4-quadrant power amplifier (optionally also for active loads).
Designed specifically for superconductivity applications, this superconductivity power supply family is series regulated via a set of parallel transistors which are driven from a pre-regulation stage which utilises phase controlled thyristors. In this manner, the power lost across the output transistors is kept to as minimum. Thus, the final control element always has a low power dissipation in energizing and static constant current mode. In de-energizing mode, the transistor stage is working as a current sink and the power is dissipated by means of either air or water cooling.